For the complete documentation index, see llms.txt. This page is also available as Markdown.

Laser Tool

Measure distances on planar faces easily using the laser tool.

  1. Under the Measure icon, click Laser Tool or use the M shortcut.

  2. Left-click any surface to place the laser origin. From this location, a visible laser line will be shot in the local X- and Y-directions along the indicated surface. The laser line will continue along the surface, even across multiple parts if these parts have surfaces aligned with the indicated face. If available, a laser line perpendicular to the indicated face (local Z-direction) will be shot towards the nearest object. If the surface is not perfectly horizontal or vertical, the slope will be indicated in degrees, and a black arrow indicates in which direction the surface slopes down. Laser lines are only shot from planar faces; on a curved face no lines appear.

  1. Left-click any surface to place the laser origin in a new location, or grab the laser origin by left-clicking and holding, and drag it around for precise placement. Hold Ctrl while clicking to keep the current direction of the laser lines. Press Esc to remove the laser and place a new one.

  2. (optional) Switch on Turn on thickness measure in the command center. Hover an element to highlight it, then click one of its faces: a single laser line is shot through the element, perpendicular to that face, and shows its thickness. Hold Ctrl while clicking to measure only the clicked part instead of the whole assembly.

The direction of the laser lines is based on a local analysis of the geometry, and in case of rectangular surfaces with straight angles the laser lines should always align with this surface. For more complex geometry (e.g. a pentagon), you can redirect the laser lines by moving the laser origin close to the edge you want to align with.

Distances are displayed in the length unit of the project. Project owners can change the length unit in the project units.

Last updated